Stereoförstärkare (Utgångna modeller)

Rekommendationer

SA-14S1
NA-11S1

Se olika vinklar >

PM-14S1

Överblick
Specifikationer
Nedladdningar
Teknologi

Available in black or champagne colour, the new 14 Series features an entirely new pre-amp design and represents a quantum leap forward in performance. This is the epitome of extreme quality and is, quite simply, a masterpiece. As you would expect from such an elite amp, it includes exceptionalquality components such as Toroidal transformer and subsystems throughout its construction. In addition, it incorporates improved customized components, Marantz own developed HDAMs and the use of a more efficient electrical signal path. These elevate the audio quality to an even more sublime level. The PM-14S1 also comes with a new remote controller, which features a stylish black anodized aluminium top, and which can also control the SA-14S1 Player. The final touch of elegance is supplied by the special Marantz-made solid copper speaker terminals, for effortless and powerful signalling to your loudspeakers. This is luxury to the extreme.

Finesser

Kanaler	2
Current Feedback Topology
Phono EQ: Standard / Current Feedback / Constant Current Feedback	/ /
HDAM version	SA3, SA2
Transformator nätdel: Toroid/El	/
Högkvalites audiokomponenter
Anpassade komponenter
Symmetrisk kretskortslayout
Kylfläns av extruderad aluminium
Balans/Bas/Diskant/Loudness	/ / /

Övrigt

Linear Drive strömförsörjning
Linjär volymkontroll
BI-AMP och multikanalsmöjlighet
Shottky dioder
Ingångsbuffert förstärkare (alla ingångar / endast CD)	/
Separata kylflänsar
System blockavskärmning: koppar / metall / ingen	/ /
Bottenplatta med dubbla lager
Lågbrusigt LCD teckenfönster
Source Direct
Effektförstärkare direkt
Standby tillstånd

In- och utgångar

Audio ingångar	6
Phonoingång: MM / MC	/
Audio utgångar	2
Pre-ut / Main-in	1 /
Effektförstärkare Direct IN
Guldpläterade kontakter
Högtalarterminal: Skruvterminal / Marantz / WBT	/ SPKT-100 /
Antal terminaler	2
D-Bus
Flytande kontrollbus (3.5 mm mono jack x 2)
Heörlur ut

Specifikationer

Utgångseffekt (8 / 4 Ohm RMS)	90 W / 140 W
Frekvensomfång	5 Hz-100 kHz
Total harmonisk distorsion	0.02%
Dämpfaktor	100
Ingångskänslighet: MM	2.7 mV / 47 kOhm
Ingångskänslighet: MC	270
Signal/brusförhållande MM / MC	86 / 75 dB
Ingångskänslighet: högnivå	240 mV / 20 kOhm
Signal/brusförhållande högnivå	106 dB (2V input)
Ingångskänslighet: effektförstärkare direkt IN	1,7V / 20 kohm
Signal/brusförhållande: effektförstärkare direkt IN	125 dB

Generellt

Finns i varianterna: Guld / Silver / Svart / Silver-Guld	/ / /
Frontpanel av metall
Effektförbrukning i W	220 W
Standby förbrukning i W	0,2 W
Automatisk avstängning
Avtagbar strömkabel
Fjärrkontroll	RC001PMSA
Systemfjärrkontroll funktion
Maximum Dimensions (W x H x D) in mm	440 x 123 x 453
Vikt i kg	18.5

Current Feedback

Current Feedback amplification is a well known, Marantz’ original circuit technology. The Current Feedback amplifier technology fits perfectly with the high requirements set for Super Audio software providing wide-bandwidth, high-speed reproduction. The impedance at the Current Feedback point is limited resulting in a very low phase shift. Marantz receivers and amplifiers equipped with Current Feedback can keep the phase compensation via Negative FeedBack (NFB) to a minimum, resulting in high through-rate, excellent transient response and superb sonic transparency for the full bandwidth. Unlike conventional Voltage Feedback amplification, the Current Feedback amplification makes the power amplifier in-sensitive to difficult loudspeaker loads.

Customized Components

On paper an electrical component might look excellent but the result may fall short of the combined design expectations. Marantz selects the appropriate components for the specific design application. In some cases it’s simply not possible to use standard components that meet the high Marantz standards. These components will then be specially made for Marantz in close cooperation with the Marantz engineers.

HDAM SA3

Marantz developed its own discrete circuit boards to replace standard IC's. These HDAM's consists of discrete surface mount components with short mirror image L/R signal paths. Those devices are doing exactly the same thing as the Op-Amps, but outperform the regular IC Op-amps dramatically in terms of the Slew Rate and reduced noise level, resulting in a much more dynamic, accurate and detailed sound. Over the years Marantz developed different types of the HDAM to improve quality and to fit to the special requirements of a product category like CD or amplifier.

Power Amp Direct

Power Amp Direct extends the flexibility of an integrated amplifier for use within a stereo set or as a power amplifier within a multichannel set up. With Power Amp Direct switched off, it acts as a normal integrated amplifier for enjoying perfect sound quality in a stereo set up. With Power Amp Direct switched on, it uses the power amplifier for driving the front left and right speakers within a multichannel set up, using the surround channels from your AV receiver. What’s more, it does all this with a single push of a button, without changing wires. The Power Amp Direct can also be used for a stereo bi-amping set up.

Shottky Diodes

A Shottky diode is a special type of diode with a very low forward-voltage drop compared to normal diodes. This lower voltage drop translates into higher system efficiency. Shottky diodes have very fast signal handling, can easily stay higher temperatures and are sensitive very low voltages.

Symmetrical Circuit Layout

To achieve the best possible sonic performance, signal paths need to be short, direct and mirror imaged. The construction of our circuitry provides improved stereo imaging by ensuring close to perfect symmetry between right and left channel layout.

Toroidal Transformer

Toroidal transformer has several advantages over a normal EI core transformer. It is very efficient and therefore delivers more power compared to the same size of an EI core transformer. In addition, due to its shape, the electromagnetic radiation and the mechanical vibration are extremely low all ending in a better sound quality.